Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Under Cabinet Puck lights rapid burn out

User: Npstewart, Location: Lockport, IL

Asked on: Monday, February 28, 2011 at 12:19 pm EST
Answered on: Tuesday, May 14, 2024 at 2:10 am EDT

Question: I have some under cabinet puck lights with Bi-Pin G8 Halogen bulbs controlled via touch pad tri-level dimmer. The problem I have is that the bulbs tend to burn out about every 2 months, and the other day they all burned out at one time. I am almost positive there is something wrong either with voltage spikes or something down the line. Does anyone have any suggestions? These bulbs are almost $4.00 each!Thanks Guys

Possible Causes



Voltage spikes

Power fluctuations can damage halogen bulbs. Check voltage at the light fixture using a voltmeter. It should be within 10% of the rated voltage for the bulbs.


Incompatible dimmer

If the dimmer is not designed for halogen bulbs, it can cause excessive heat and premature bulb failure.

Loose connections

Poor electrical connections can create resistance, causing bulbs to overheat and burn out.


Overheating

Puck lights can generate significant heat, especially if they are enclosed. Ensure adequate ventilation and avoid installing them in closed spaces.

Faulty wiring

Damaged or improperly installed wiring can lead to voltage drops or power interruptions.


Improper bulb type

Using bulbs with the incorrect wattage or base type can cause overheating and burnout.

Troubleshooting Steps

1.

Check Voltage

Measure the voltage at the light fixture with a voltmeter. If it fluctuates or is outside the recommended range, consult an electrician.2.

Replace Dimmer

If the dimmer is not compatible with halogen bulbs, replace it with one that is specifically designed for them.3.

Tighten Connections

Inspect all electrical connections and tighten any loose wires. Use pliers or a screwdriver to ensure a secure fit.4.

Provide Ventilation

Ensure that the puck lights have adequate ventilation to dissipate heat. Consider installing vents or fans.5.

Check Wiring

If voltage and connections appear normal, have an electrician check the wiring for any faults.6.

Use Correct Bulbs

Use halogen bulbs with the correct wattage and base type as specified by the light fixture.7.

Consider Surge Protector

Install a surge protector between the light fixture and the power supply to mitigate power fluctuations.

Additional Tips:
Keep a spare set of bulbs on hand. Monitor the lights regularly for any signs of flickering or dimming, which may indicate impending bulb failure.* Use high-quality bulbs designed for long life. Flag for review

Previous Question Next Question