Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Residential service load calculation

User: leelectricco, Location: NJ/PA

Asked on: Monday, February 28, 2011 at 3:51 pm EST
Answered on: Tuesday, May 14, 2024 at 2:10 am EDT

Question: In calculating service size for residential how do you decide to go by the standard calculations or the optional calculations? I used the Mike Holt worksheet for this but seems like a big difference between the two different figures.

Factors to Consider When Choosing Between Standard and Optional Service Calculations



Load Profile

If the residential load profile is typical and consists primarily of lighting, small appliances, and electric heating, the standard calculation method may be sufficient.


Large Appliances

If the residence has large appliances, such as an electric water heater, electric oven, or central air conditioner, the optional calculation method should be used to account for their higher demand.

Future Expansion

If there is a possibility of future additions or renovations that could increase the electrical load, the optional calculation method is advisable.


Local Code Requirements

Check with your local electrical code to determine if it specifies mandatory use of standard or optional service calculations.

Mike Holt Worksheet

The Mike Holt worksheet provides both standard and optional calculation methods.

Standard Calculation

Calculates service size based on estimated square footage and lighting load in watts per square foot.


Optional Calculation

Requires detailed calculations of the circuit and equipment loads in the residence.

Difference Between Standard and Optional Calculations

The optional calculation method typically results in a larger service size compared to the standard calculation. This is because it accounts for all the equipment and loads in the residence, including those that may not be used simultaneously.

Recommendation:


If you are uncertain about the electrical load profile or anticipate future expansion, it is generally advisable to use the optional calculation method to ensure adequate service capacity. However, if the residence has a relatively simple load profile and no major electrical equipment, the standard calculation method may be sufficient. Flag for review

Previous Question Next Question