User: SPierce, Location: Nebraska
Asked on: Tuesday, March 1, 2011 at 9:31 am EST
Answered on: Tuesday, May 14, 2024 at 2:12 am EDT
Question: I always have a hard time discerning when to use a fused or non-fused disconnect. Is there any code reference concerning this or does anyone have any suggestions.
Code Reference
National Electrical Code (NEC), Article 408.10(A) Canadian Electrical Code (CEC), Rule 26-228Suggestions for Discerning Fused vs. Non-Fused Disconnects
Fused Disconnects
Use where branch circuit short-circuit and ground-fault protection is required. Typically used for equipment that draws high starting current, such as motors, transformers, or HVAC units. Protects the equipment and wiring from damage caused by overcurrents.
Non-Fused Disconnects
Use where only isolation (disconnection) is required, without overcurrent protection. Typically used for lighting circuits, receptacles, and other non-critical loads. Provide a convenient means of de-energizing equipment for maintenance or repairs.
Consider the following factors when selecting between fused and non-fused disconnects
Load Type
Determine the type of load the disconnect will be protecting (e.g., motor, lighting, etc.)
Overcurrent Protection
Consider whether the load requires overcurrent protection (e.g., motors need protection from overload)
Fault Current Levels
Check the available fault current at the location to ensure the disconnect can withstand potential short-circuit currents.
Maintenance Frequency
If the equipment requires frequent maintenance or repairs, a non-fused disconnect may be more convenient than a fused disconnect.
Cost
Fused disconnects typically cost more than non-fused disconnects.
Additional Tips: Always refer to the manufacturer's specifications for specific requirements.* Consult with a licensed electrician if you have any doubts about the appropriate type of disconnect to use. Flag for review