Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Under Cabinet Lighting Troubleshooting Issue

User: wptski, Location: Warren, MI

Asked on: Tuesday, March 1, 2011 at 9:31 am EST
Answered on: Tuesday, May 14, 2024 at 2:12 am EDT

Question: A while back had a relative ask me to help them with their under cabinet lighting as some went out. Having never worked on them before, I found out they were 12V and the transformers were in the basement.One was cold and the other warm, no skills required but as I remember, I put an amp meter on the input wires to verify. Later when they received the part, I went back to install it.They contacted me that the other bank went out, they discovered that the other transformer is bad and have a new one. I later found out that a friend electrician used a clamp meter that I gave them the last time to replace the defective part.They said the power was OFF. I used a Fluke VoltAlert, no power. Breaker ON, still no chirping, verify chirp at another circuit. Pull the twist caps OFF, use a T+ Pro, no power. Use a 87V, still no power. Use an extension cord from another circuit, still shows no power. Breaker OFF, other working lights go OFF as well. Disconnected both transformer wires, VoltAlert chirps, 87V and T+ Pro show power.I connected the new transformer and all is well.Connected the bad one at home, VoltAlert chirps and the T+ Pro reads 120V.I did a search later and these so-called transformers are really electronic power supplies with a HF 12V output, on some there is no output without at least a 20W load and its output can only be read correctly with a RMS DMM .Not sure what would fool the VoltAlert, etc. but one transformer was from the original install years ago done by the previous home owner.Anybody have a logical reason for what I described here? When something can fool a VoltAlert, T+ Pro and a 87V, it’s a good way to end up touching a hot wire!!I wish that I would have at least tried to use the VoltAlert with the new transformer installed.

Possible Explanations



Induced Voltage

When the defective transformer was disconnected, it may have generated a transient voltage that fooled the test instruments. This could be caused by inductive coupling between the transformer windings and the test leads.


Phantom Voltage

Certain electronic devices can exhibit "phantom voltage" even when the power is supposedly off. This occurs due to residual energy stored in capacitors or other components. The VoltAlert and other test instruments may have detected this phantom voltage.

Resistance in the Test Leads

The test leads themselves can introduce resistance, especially if they are long or of poor quality. This resistance can reduce the voltage reading, potentially leading to a false negative reading.


Faulty Test Instruments

It's possible that one or more of the test instruments was faulty and gave an incorrect reading. This is unlikely in the case of the VoltAlert, which is known for its reliability, but it's worth considering.

AC/DC Confusion

Some test instruments are only designed to measure AC voltage, while others can measure both AC and DC. If the transformer outputs DC voltage, it may not be detected by AC-only test instruments.


High Frequency Output

As you mentioned, some electronic power supplies used in under-cabinet lighting output high-frequency AC voltage. This high frequency may not be detected accurately by all test instruments, especially if they are not designed to measure high-frequency signals.

Recommendations:
Always exercise caution when working with electrical systems, even if the power is supposedly off. Use multiple test instruments to verify the absence of voltage. This can help rule out false readings caused by induced voltage or faulty instruments. Consider using a non-contact voltage tester, such as a VoltAlert, as a preliminary safety measure. If you are unsure about the voltage output of the transformer, consult the manufacturer's specifications or use a test instrument specifically designed to measure high-frequency signals. Flag for review

Previous Question Next Question