Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Setting up a backboard for a freestanding service

User: Electron_Sam78, Location: Palm Bay, FL

Asked on: Tuesday, March 1, 2011 at 9:09 pm EST
Answered on: Tuesday, May 14, 2024 at 2:14 am EDT

Question: I'm putting together a proposal for a new 800a service. It's a freestanding service -no attachment ot a building. I've got a 42"Wx62"H safety switch, a 42"Wx76"H MDP, and a 22" wide sub panel. In the past I've just used pressure treated lumber but I've noticed some old services around here like that that have the post rotting out. So, I want to build this using galvanized and stainless steel. For the piers I'm going to use 4"x4" galvanized square steel tube 1/4" thick but that's about as far as I've gotten as far as framing. Maybe Unistrut accross the piers to mount the equipment? Will that be hefty enough to hold the stuff?

Framing Considerations for Freestanding 800A ServicePiers

4"x4" galvanized square steel tube 1/4" thick is suitable for the piers. Ensure the piers are buried deep enough to provide adequate support in the soil conditions.

Cross Members

Unistrut can be used as cross members to mount the equipment. Choose the appropriate channel size and thickness based on the weight of the equipment and installation conditions. Consider using aluminum Unistrut for lighter weight and corrosion resistance.

Mounting Equipment

Use stainless steel bolts and washers to mount the safety switch, MDP, and sub panel to the Unistrut cross members. Ensure adequate spacing between the cross members to accommodate the mounting brackets of the equipment.

Bolting Piers to Cross Members

Use galvanized or stainless steel bolts to connect the piers to the Unistrut cross members. Use appropriate bolt size and grade for the load and installation conditions. Consider adding washers between the piers and cross members to distribute the load.

Additional Considerations



Corrosion Protection

All steel components should be galvanized or painted with a corrosion-resistant coating.


Seismic Requirements

If the area is prone to earthquakes, consider seismic bracing or using a stand that incorporates seismic protection features.

Access and Maintenance

Provide access for equipment maintenance and inspection. Consider using a platform or ladder for easy access.


Grounding

Ensure proper grounding of all equipment and the structure.

Recommended Channel Size and Thickness for Unistrut Cross Members:


For a 800A service with the specified equipment, a 12 gauge, 6" wide Unistrut channel is typically sufficient. The actual size and thickness may vary depending on the equipment weight and installation conditions. Flag for review

Previous Question Next Question