Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 110V Smoke mystery

User: Oakey, Location: New Jersey

Asked on: Tuesday, March 1, 2011 at 9:11 pm EST
Answered on: Tuesday, May 14, 2024 at 2:14 am EDT

Question: I try not to bug you guys but I'm stumped with this. The house has 9 BRK smokes and 2 CO/Smoke combos interconnected 110V with battery backup. In the middle of the night it seems they go into alarm for about 3 seconds, when the homeowner kills the 110V and they run on battery they are fine .I thought maybe a power company switchover in the middle of the night but nothing else shows signs of that, time clocks etc. The detectors are about 6 years old... I also vacuumed them and tested everything seems right. I replaced the CO/Smoke combo on a hunch but it didn't do anything to fix it.I hesitate to replace them all just to have this issue reoccur. Any suggestions would be helpfulThanks

Possible Causes



Low batteries

Even though the detectors have battery backup, low batteries can still cause false alarms. Replace the batteries in all detectors.


Dust buildup

Dust can accumulate on the sensors inside the detectors, causing false alarms. Clean the detectors regularly with a vacuum cleaner.

Power surge or fluctuations

Power surges or fluctuations can cause detectors to malfunction. Check for any evidence of power issues in the house.


Loose wiring

Loose or faulty wiring can cause intermittent power loss or fluctuations. Inspect the wiring to the detectors and ensure it is secure.

RF interference

Radio frequency (RF) interference from nearby devices, such as cell phones, cordless phones, or wireless routers, can trigger false alarms in smoke detectors. Remove or relocate any potential sources of interference.


Aging detectors

Smoke detectors have a lifespan of 8-10 years. After this time, they may become less reliable and prone to false alarms.

Troubleshooting Steps

1.

Replace the batteries

Replace the batteries in all detectors, even if they appear to be working.2.

Clean the detectors

Use a vacuum cleaner to gently remove dust from the sensors and grills of the detectors.3.

Check for power issues

Use a voltage tester to check the power supply to the detectors. Ensure that the voltage is stable and within the specified range.4.

Inspect the wiring

Visually inspect the wiring to the detectors for any damage or loose connections. Use a multimeter to test for continuity and proper grounding.5.

Eliminate RF interference

Identify any potential sources of RF interference and move them away from the detectors.6.

Replace aging detectors

If the detectors are over 8-10 years old, consider replacing them.

Additional Tips:
Test all interconnected smoke detectors simultaneously to ensure they are all functioning correctly. Keep smoke detectors clean and free of dust, cobwebs, or other debris. Do not paint over smoke detectors, as it can block the sensors. If the problem persists after following these steps, contact a qualified electrician or fire alarm technician for further assistance. Flag for review

Previous Question Next Question