User: al hildenbrand, Location: Minnesota
Asked on: Wednesday, March 2, 2011 at 12:14 am EST
Answered on: Thursday, May 23, 2024 at 5:53 pm EDT
Question: A dwelling built in 1952, had an addition and relocation of the service entrance and service disconnect around 1975. The original panel had its overcurrent devices and bus assembly removed, except for the neutral bar.The original branch circuits were extended from the old panel to the new service center.My question: Was there a way, by Code, from around 1975, to use that old neutral bar to splice all the neutrals, downstream of the old panel, together into one massively parallel set of neutrals between the old panel and the new service center?
Yes, there was a way to use the old neutral bar to splice all the neutrals together.
According to the 1975 National Electrical Code (NEC), Section 384-16(b), it was permissible to use a neutral bar in a panelboard that had been converted to a junction box.The neutral bar had to be bonded to the enclosure and had to be used to connect all the neutral conductors from the branch circuits.This method of splicing the neutrals together was common at the time and was considered to be safe and acceptable.
However, it is important to note that this practice is no longer permitted by the current NEC.
The 2020 NEC requires that all neutral conductors be spliced together in a junction box or other approved enclosure.This change was made to improve safety and to reduce the risk of electrical fires.If you are working on an electrical system that has been installed in accordance with the 1975 NEC, it is important to be aware of this change and to bring the system up to the current code requirements. Flag for review