Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Certifications: Class I, II; Div 2; Groups

User: dasarmin, Location: Texas

Asked on: Friday, March 4, 2011 at 8:33 am EST
Answered on: Tuesday, May 14, 2024 at 2:20 am EDT

Question: I have a production area that?s Class II, Division II, Group F (Dusts, Contained or not present in normal operation, Carbon Dust).The Operator?s Interface is via a PC/TS (Xycom 15? PC / Touchscreen) mounted into a NEMA 9 enclosure (Rated for Class II, Div I, Group E, F or G).Also, in this enclosure are a power supply, duplex outlet, CBs, etc; which are not Class II, Div II, Group F; but since these are inside the enclosure these don?t have to be certified Class II, Div II, Group F.The PC/TS manufacture has discontinued my current PC/TS and their replacement is only certified for Class I, Div II, Groups A, B, C, D.The question is, can the new PC/TS be installed into NEMA 9 and still meet code requirements for the room? The only exposure to the room is the bezel / Touchscreen, all the electronics (chassis) is essentially inside the NEMA 9 enclosure. The bezel?s gasket / seal is certified Class I, Div II, Groups A, B, C, D which is rated for Gases and Vapors. So you might think this would also keep out Dust

According to the National Electrical Code (NEC), Class II, Division II, Group F locations are hazardous areas where flammable dusts are present in normal operation. To ensure safe operation in such areas, all electrical equipment must be certified for Class II, Division II, Group F.In the scenario you described, the NEMA 9 enclosure is rated for Class II, Division I, Group E, F, or G. This means that the enclosure itself meets the requirements for Class II, Division II, Group F locations. However, the PC/TS, power supply, duplex outlet, and CBs inside the enclosure are not certified for Class II, Division II, Group F.The NEC does not explicitly address the use of enclosures to isolate non-certified equipment in hazardous areas. However, the intent of the code is to prevent ignition sources from being present in hazardous areas. Installing non-certified equipment inside an enclosure that is rated for the hazardous area may not provide adequate protection against ignition.In addition, the bezel/touchscreen of the PC/TS is exposed to the hazardous area. Even though the gasket/seal is certified for Class I, Division II, Groups A, B, C, D, it is not certified for Class II, Division II, Group F. This means that the bezel/touchscreen may not be able to prevent dust from entering the enclosure and potentially igniting.Based on the information provided, it is not advisable to install the new PC/TS into the NEMA 9 enclosure and use it in a Class II, Division II, Group F location. The PC/TS and other components inside the enclosure are not certified for Class II, Division II, Group F, and the bezel/touchscreen may not be able to prevent dust from entering the enclosure. This could create an ignition hazard and violate the NEC.It is recommended to contact the authority having jurisdiction (AHJ) for the specific requirements and interpretations that apply to your installation. Flag for review

Previous Question Next Question