Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: FSD Control Modules

User: Alwayslearningelec, Location: NJ

Asked on: Friday, March 4, 2011 at 10:45 am EST
Answered on: Tuesday, May 14, 2024 at 2:21 am EDT

Question: It always seems like there is confusion pertaining to the wiring/install of these? When control modules are used for FSD where are they usually mounted, in the closet or by the FSD? Do they get power and fire alarm wiring? I kow there is sometimes a relay invloved. If anyone can simplify this for me I weould greatly appreciate it. I know the spec governs a lot regaridng modules for FSD such as for purcge, 2000cfm or above etc. Any help in helping me understand would be great. I don't deal with FA much at all.

Mounting Location of Control Modules

Control modules for FSD are typically mounted in the fire alarm control panel (FACP) cabinet or a separate enclosure near the FSD.

Wiring

Control modules for FSD require the following wiring: Power

Typically 12VDC or 24VDC from the FACP


Fire Alarm Wiring

Fire alarm signals (Initiating Device Circuits) from smoke or heat detectors in the protected area

Purge Control

Wiring to activate the FSD fan for purge operations

Relay Involvement


In some cases, a relay may be used to isolate the FSD fan from the control module. This is done to protect the control module from electrical surges or damage from the fan motor.

General Operation

When a fire alarm signal is received by the control module, it activates the fan to purge smoke from the protected area. The purge time and fan speed are typically configurable parameters on the control module.

Simplification
The control module serves as an interface between the fire alarm system and the FSD. It provides power and control signals to the FSD fan. The module can be mounted in the FACP cabinet or a nearby enclosure. Required wiring includes power, fire alarm signals, and purge control. A relay may be used for electrical isolation and protection.

Additional Notes The specific installation requirements may vary depending on the manufacturer and model of FSD and control module. The National Fire Protection Association (NFPA) provides guidelines for FSD installation and maintenance in NFPA 90A, "Standard for the Installation of Air Conditioning and Ventilating Systems."* It is important to refer to the manufacturer's instructions and consult with a qualified technician for proper installation and maintenance of FSD and control modules. Flag for review

Previous Question Next Question