User: mphillipps, Location: Tennessee
Asked on: Saturday, March 5, 2011 at 12:14 pm EST
Answered on: Tuesday, May 14, 2024 at 2:22 am EDT
Question: I recently replaced a faulty FPE with a new breaker. On this kitchen circuit was a 1500w micro, 1800w toaster, stove fan & light. I explained to the owner that running these appliances will trip the 20 amp breaker.To demonstrate, I place my amp meter on the circuits wire and turned on the micro and toaster. The meter read 29 amps. I waited (~1 minute). Nothing.My question: At what amperage and at what time will a breaker trip? Or could this be a faulty (new) breaker?
Circuit Breaker Trip Characteristics
Circuit breakers are designed to trip at a specific amperage and within a specific time frame to protect the circuit from overloads and short circuits. The trip characteristics for different types of circuit breakers vary.
For a standard 20-amp residential circuit breaker
Instantaneous Trip
Tripping occurs within a few milliseconds at or above 100% of the rated amperage (20 amps or higher).
Time-Delay Trip
Designed to allow brief overloads by tripping within a few seconds at 150-200% of the rated amperage (30-40 amps).
In Your Case
Since you measured 29 amps and the breaker did not trip, it suggests that either:1.
The breaker is faulty
The new breaker may be defective and not tripping at the correct amperage or time.2.
The circuit wiring has a high resistance
This can cause the voltage drop across the circuit to increase, resulting in higher current readings on the ammeter without actually exceeding the breaker's trip threshold.
Troubleshooting
To determine the cause:
Check the breaker again
Swap it with a known-good breaker from another circuit of the same rating.
Inspect the circuit wiring
Look for any loose connections, damaged wires, or high-resistance points that could be causing the voltage drop.
Use a different ammeter
It's possible that the first ammeter used was inaccurate. Try measuring the current with a different meter.
Contact a licensed electrician: If you cannot resolve the issue yourself, it's recommended to seek professional help from a licensed electrician to ensure the safety of the circuit. Flag for review