User: thetacon, Location: Indiana
Asked on: Saturday, March 5, 2011 at 3:19 pm EST
Answered on: Tuesday, May 14, 2024 at 2:23 am EDT
Question: the situation is that I have a new multi unit residential project that has a heat recovery system for ventilation of all the units. each unit has a 120volt damper on the supply and exhaust controlled by the FA. are the damper motors required to have a disconnect located at each unit?
NEC Requirement
Section 424.20 of the National Electrical Code (NEC) requires a disconnecting means to be provided for each motor that is not permanently connected to the supply circuit.
Interpretation
In this case, the damper motors are not permanently connected to the supply circuit because they are controlled by the fire alarm (FA) system. Therefore, a disconnecting means is required for each damper motor.
Location of Disconnecting Means
The NEC does not specify a specific location for the disconnecting means. However, it is generally recommended to locate the disconnecting means where it can be easily accessed for maintenance and troubleshooting purposes. In a residential setting, it is common to locate the disconnecting means at the unit's electrical panel.
Conclusion:
Yes, the damper motors in the heat recovery system are required to have a disconnect located at each unit. This disconnect should be easily accessible for maintenance and troubleshooting purposes. Flag for review