Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Perimeter Surface Grid- Spa or Hot Tub

User: little george, Location: Chapel Hill, NC

Asked on: Sunday, March 6, 2011 at 11:46 am EST
Answered on: Tuesday, May 14, 2024 at 2:24 am EDT

Question: The NEC requires a 3 foot perimeter surface grid for a outdoor pool per 680.26(B)(2). Article 680.42 requires that outdoor Spas and Hot Tubs be wired per Parts I and II of 680. I don't see a problem with this unless the Spa or Hot Tub is on a wooden deck. What would an inspector normally ask for by way of a perimeter surface grid if the tub or spa were on a wooden deck?This is confused by the fact that the perimeter surface grid is not required for a storable pool as shown in Part III.

For Spas or Hot Tubs on Wooden Decks

Inspectors would typically require a perimeter surface grid even if the spa or hot tub is located on a wooden deck. The reason for this is that wooden decks are considered to be conductive surfaces, and therefore require a perimeter surface grid to prevent electrical shock.

Perimeter Surface Grid Requirements

The perimeter surface grid for a spa or hot tub on a wooden deck must meet the following requirements: Installed within 3 feet of the perimeter of the spa or hot tub. Consists of a conductive material such as copper or aluminum. Has a minimum wire size of #8 AWG. Is connected to the equipment grounding conductor of the wiring system.

Exception for Storable Pools

Article 680.42(A)(1) does not require a perimeter surface grid for storable pools. This exception applies to spas or hot tubs that are intended to be stored when not in use. However, if a storable spa or hot tub is installed on a wooden deck, a perimeter surface grid is still required.

Consequences of Non-Compliance:


Failure to install a perimeter surface grid around a spa or hot tub on a wooden deck can result in electrical shock or electrocution. It can also lead to a failed inspection and prevent the spa or hot tub from being used. Flag for review

Previous Question Next Question