Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: soft start 3phase 480V motor

User: nizak, Location: NE (9.06 miles @5.9 Degrees from Winged Horses)

Asked on: Sunday, March 6, 2011 at 9:54 pm EST
Answered on: Tuesday, May 14, 2024 at 2:25 am EDT

Question: Have a piece of industrial equipment that shut down after the safety device(photo eyes) were tripped. In order to restart this the main power has to be shut off and then re-energized.In the process of doing this, the disconnect switch handle broke(don't ask me how)so the maintenence man by-passed the disco and hooked the line to load side with wire nuts. After doing so, he tells me that he can no longer get the machine to start. He has checked voltage and assures me that it is fine along with fuses that are also ok.I have not been to the job yet, but am not real familiar with soft start motor controls. With what I have described, any thoughts on what to start looking for? They have supposedly had this situation many times with the safetys tripping out and it's always reset and came back up after the disco was turned off and back on again. Thanks much.

Possible Causes



Damaged Soft Starter

Bypassing the disconnect switch may have caused a power surge that damaged the soft starter. This can prevent the motor from starting.


Loose Connections

The wire nuts used to bypass the disconnect switch may have become loose, interrupting the power supply to the motor.

Tripped Internal Circuit Breaker

The soft starter may have an internal circuit breaker that tripped due to the power surge.


Overload

If the motor was repeatedly started and stopped without the soft starter, it may have overheated and tripped the internal overload protection.

Motor Damage

If the motor was subjected to multiple power surges, it may have sustained damage that prevents it from starting.

Troubleshooting Steps

1.

Verify Power

Ensure that power is reaching the machine by measuring voltage at the input terminals of the soft starter.2.

Inspect Soft Starter

Check for any visible damage or loose components on the soft starter.3.

Check Connections

Ensure that all wire nut connections are tight and secure.4.

Test Internal Circuit Breaker

If accessible, try resetting the internal circuit breaker on the soft starter.5.

Verify Overload

Measure the resistance of the motor windings to check for any open circuits that may indicate an overload.6.

Check Motor

Inspect the motor for any signs of damage, such as burnt windings or a loose rotor.

Additional Considerations:
Bypassing the disconnect switch is a safety hazard and should be avoided. The soft starter manufacturer may have specific troubleshooting guidelines that should be consulted. If the problem persists, it may be necessary to contact the equipment manufacturer or a qualified electrician for further assistance. Flag for review

Previous Question Next Question