Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Wye-Delta H2 floating

User: 024engineer, Location: Henrico County, VA

Asked on: Tuesday, March 8, 2011 at 10:02 am EST
Answered on: Tuesday, May 14, 2024 at 2:28 am EDT

Question: What would happen if the H2 bushing was grounded on the primary side of a 3 phase Unground Wye-Delta bank while energized? What is the voltage between ground and the H2 bushing?

Consequences of Grounding the H2 Bushing on the Primary Side of a 3-Phase Ungrounded Wye-Delta Bank

When the H2 bushing on the primary side of an ungrounded wye-delta bank is grounded while energized, a fault occurs. This results in:

High fault currents

The delta-connected secondary creates a low-impedance path for fault current to flow.


Arcing

The fault creates an arc between the H2 bushing and ground.

Overheating

The fault current causes excessive heating, which can damage the transformer, equipment, and surrounding infrastructure.


Voltage transients

The sudden change in the fault circuit conditions can generate voltage transients that can overstress other components.

Voltage Between Ground and the H2 Bushing

With the H2 bushing grounded, the voltage between ground and the H2 bushing is essentially

zero volts
. This is because the fault current flows through the low-impedance path created by the delta secondary and ground.

Additional Considerations: The fault may trip the overcurrent protection devices, interrupting the power supply to the load. The fault can also cause harmonics and other disturbances on the power system, potentially affecting other equipment and devices.* Prompt action is crucial to isolate the faulty transformer and prevent further damage or injuries. Flag for review

Previous Question Next Question