Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Fire alarm horn inside of a walk-in air handler??

User: salm10, Location: London, England

Asked on: Tuesday, March 8, 2011 at 5:18 pm EST
Answered on: Tuesday, May 14, 2024 at 2:30 am EDT

Question: Has anyone ever heard of a local fire marshall requiring an a/v indicating device inside of an air handler? I am working with a local AHJ and he seems to think so. This is an air handler with about a 75 hp motor inside of a walk in built up box. The only time anyone would be in there is to change filters, service the motor, etc. I can't think of any reason why anyone would be in there with the fan running, but the AHJ is claiming that you cannot hear the horn in the mechanical room if you are standing in the fan.Has anyone ever had to install horns in this kind of equipment?

NFPA 72: National Fire Alarm and Signaling Code

NFPA 72, the national standard for fire alarm and signaling systems, does not explicitly require the installation of indicating devices within air handlers. However, the AHJ may have adopted local amendments to the code that include such a requirement.

Local Codes and Amendments

Local fire marshals and AHJs have the authority to adopt amendments to NFPA 72 and other national codes to address specific local conditions and concerns. It is possible that the AHJ in your jurisdiction has adopted an amendment that requires the installation of indicating devices within air handlers.

Consultation with AHJ

To clarify the situation, you should consult with the AHJ directly. They can explain the rationale behind the requirement and provide guidance on how to comply.

Possible Rationale for Requirement

There are some potential reasons why the AHJ may require an indicating device inside the air handler: Limited access

The AHJ may be concerned that personnel working on the air handler could be exposed to a fire or hazard without being alerted by an audible signal.


Noise mitigation

The mechanical room may be noisy, making it difficult to hear an indicating device outside the air handler.

Additional safety measure

The indicating device could provide an additional level of safety for personnel working in the air handler.

Installation Considerations


If the AHJ does require an indicating device inside the air handler, the following considerations should be taken into account:
Location

The device should be positioned in a visible and audible location within the air handler.

Type

The device should be an approved smoke detector, heat detector, or multi-sensor detector.


Power source

The device should be powered by a reliable source of electricity.*

Testing

The device should be tested regularly to ensure its proper operation.

Conclusion


While it is not a common requirement, it is possible that your local AHJ has adopted an amendment to NFPA 72 that requires the installation of indicating devices within air handlers. It is important to consult with the AHJ to understand the rationale behind the requirement and how to comply. Flag for review

Previous Question Next Question