Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: required spaces for safety switches

User: JUSTEINEE, Location: Springfield

Asked on: Tuesday, March 8, 2011 at 5:57 pm EST
Answered on: Tuesday, May 14, 2024 at 2:30 am EDT

Question: I am a little confused and when this happens I usually confuse others along the way. So I appoligize ahead of time for any idiotic statements. Im not looking at any complicated circumstances so don't overthink it I am newb and don't know any better.What kind of space do I need around a safety switch?110.26 requires working space for equipment likely to require examination, adjustment, servicing, or maintenance.Does a safety switch fit this criteria? Without definitions for what this terms are meant to encompass I can come up arguments each way, but i tend to think that it does not meet the intended purpose of this section.404.8 gives a height requirement with exceptions for switches but it only says that switches shall be located so that they may be operated from a readily accessible place.Could i put a switch on the floor and make someone crawl to get to it? It can be reached quickly without having to climb over or remove obstacles.So if I use exception #2 and place the switch over 6'-7" in the air the only requirement is to be accessible by portable means. There doesn't need to be clearance above below or to the sides of the device only room to operate the device. Is this correct?I am just so confused. Can someone point me to the light?

Safety Switch Clearance

According to 110.26, working space is required for equipment likely to require examination, adjustment, servicing, or maintenance. Safety switches fall under this category as they may need to be reset or replaced. The specific amount of space required is not defined in the code, but the goal is to provide unobstructed access for personnel to perform these tasks.

Switch Height404.8 sets the minimum height for switches at 6 feet, 7 inches above the floor. However, there are exceptions, such as switches located in a switchboard, panelboard, or control device. Switches placed higher than 6 feet, 7 inches must be accessible by portable means, such as a ladder or stool.

Clearance Around Switch

While the code does not explicitly specify clearance around switches, it is recommended to provide adequate space for ease of operation and access for maintenance. Factors to consider include:- Clearance above the switch: Allow enough space for the hand to reach and operate the switch comfortably.- Clearance below the switch: Ensure there is sufficient space for personnel to stand or kneel to access the switch if necessary.- Clearance to the sides: Provide enough room to accommodate any wires or cables connected to the switch.

Recommendation

For a safety switch, it is recommended to provide a clear space of at least 30 inches wide by 30 inches deep in front of the switch. This space should be free of obstructions and allow personnel to safely operate and maintain the switch. Flag for review

Previous Question Next Question