User: docseabee, Location: Logan, Utah
Asked on: Wednesday, March 9, 2011 at 9:05 am EST
Answered on: Tuesday, May 14, 2024 at 2:32 am EDT
Question: First I would like to say hello to everone and for all of the support given. I am a new member however I have used the site coutless times in the past. THANK YOU ALL!!!My question is... A homeowner contacted a electrical company to upgade there service, a permit was pulled and work was complerted and even inspected. The work passed but for whatever reason (unknown to the homeowner) the company returned and told the homeowner a mistake happened and they needed to fix said problem with the panel with no reinspection. I was asked to do other work several months later and found numerous fixable issues but found the cover oversized for the in-wall panel box. The homeowner is upset paying for a new panel and recieving this type of work ... is there a code issue Im not aware of that could force a proper panel install or is the home owner forced to start over? Thanks again.
Code Issues
According to the National Electrical Code (NEC), the following code sections may apply to this situation:
NEC 110.12
All electrical equipment shall be installed and used in accordance with any instructions included in the listing or labeling.
NEC 312.8(A)(1)
Enclosed panels shall have covers securely fastened in place.
NEC 110.26
Electrical equipment shall be judged suitable for the intended use.
Contractor's Responsibility
The electrical company is responsible for installing electrical equipment in accordance with the NEC and any manufacturer's instructions. If a mistake was made during the initial installation, the company should rectify it without further expense to the homeowner.
Homeowner's Options
The homeowner has several options:
Request a Partial Refund
If the panel cover is the only issue, the homeowner could request a partial refund for the cost of a new panel.
Request a Full Refund and Redo
If there are multiple fixable issues, including the oversized panel cover, the homeowner could request a full refund and have the work redone by another contractor.
Accept the Correction
If the homeowner is satisfied with the proposed fix, they can accept the correction and waive any further claims.
Recommendations
Document the Issues
The homeowner should document the oversized panel cover and any other issues identified.
Contact the Electrical Company
The homeowner should contact the electrical company and discuss their concerns.
Consider Getting a Second Opinion
If the homeowner is not satisfied with the company's response, they can get a second opinion from another licensed electrician.
File a Complaint with the Licensing Board
If necessary, the homeowner can file a complaint with the state licensing board or local building department.
Note: It's important to communicate all concerns and expectations clearly to the contractor. The homeowner should also review the contract thoroughly to ensure that the scope of work and the expected outcome are well-defined. Flag for review