User: mbam, Location: Logan, Utah
Asked on: Wednesday, March 9, 2011 at 11:47 am EST
Answered on: Tuesday, May 14, 2024 at 2:33 am EDT
Question: I opened a wall up to do some plumbing in a laundry room and found the conduit to the dryer outlet and wall outlet is rusted off right where it comes out of the slab. I tried to get a fish through to pull another wire but no joy, even though I'll try a few more times befer I give up. There is plenty of room in the conduit.There is a copper water pipe right there. Assuming good continuity to the panel (i have not checked it yet) can I bond these outlets to the pipe? I know it's not ideal/code, but from a practical standpoint if the resistance is low enough can I get away with it?Re-piping this overhead will be a real pita.
Electrical Code Compliance
Bonding outlets to a copper water pipe is strictly prohibited by the National Electrical Code (NEC). This is because the water pipe may not provide a reliable ground path, potentially leading to electrical hazards.
Resistance Considerations
Even if the resistance between the outlets and the water pipe is low, using it as a ground path is still not advisable. The NEC requires the grounding electrode system to be of sufficient size and conductivity to ensure proper grounding and safety. A water pipe may not meet these requirements.
Practical Consequences
If the water pipe is used as a ground path, it could potentially carry electrical currents during a fault, which could damage the pipe or cause electrolysis. Additionally, if the water pipe is ever disconnected or replaced, the grounding for the outlets would be lost, creating a safety hazard.
Recommendations
Instead of bonding the outlets to the water pipe, it is highly recommended to:
Re-route the conduit
This will require more work, but it is the safest and most code-compliant option.
Replace the damaged conduit
Cut out the rusted portion and replace it with new conduit.*
Use a ground rod
Install a ground rod near the electrical panel and connect it to the grounding system. Then, run a ground wire from the panel to the conduit and outlets.
Conclusion:
While it may seem convenient, bonding outlets to a copper water pipe is against code and can create safety hazards. It is essential to prioritize electrical safety and use proper grounding methods to ensure the reliable operation of your electrical system. Flag for review