User: Jeff B, Location: Eastern Oregon
Asked on: Wednesday, March 9, 2011 at 12:20 pm EST
Answered on: Tuesday, May 14, 2024 at 2:33 am EDT
Question: I have a customer that has 320W highbays. The lamps sieze and will notunscrew. I tried nickle-anti-sieze very lightly on the lamp shell close tothe glass leaving bare metal for good connection and keeping it away fromthe tip. It works. The lamps do not fall out but they no longer break inyour hands trying to unscrew them. (You have to Unplug first and wearKevlar gloves if they are real bad)Lamps siezing is a big problem in onebuilding. One of my bosses says stop it is against code the other says it isnot against code.Is it against code? If so where in the code?
The use of nickel anti-seize on the lamp shell close to the glass is not against code. In fact, it is a common practice to prevent lamps from seizing in highbays.The National Electrical Code (NEC) does not specifically address the use of anti-seize on lamp shells. However, Section 410.14(A) of the NEC states that "Lampholders shall be installed so as to prevent contact between the base of the lamp and live parts." This requirement is intended to prevent electrical shock and fires.The use of anti-seize on the lamp shell does not create a contact between the base of the lamp and live parts. Therefore, it does not violate Section 410.14(A) of the NEC.It is important to note that the use of anti-seize on the lamp shell should be done carefully. Too much anti-seize can create a high resistance connection, which can lead to overheating and possible failure of the lamp. Flag for review