User: EE_Intern_2, Location: Ca and Wa
Asked on: Wednesday, March 9, 2011 at 3:51 pm EST
Answered on: Tuesday, May 14, 2024 at 2:34 am EDT
Question: I have two questions.Question 1. I have seen two different sets of formulas for calculating MCA and MOCP for HVAC equipment (compressor motor 16Amps RLA, condenser fan motor 3.0 A RLA, and supply & exhaust fan motor 2.8A RLA). Which set of equations below is the correct set?MCA = 1.25 * largest motor load + all other motor loadsMCA = 1.75 * largest motor load + all other motor loadsMOCP = 1.75 * largest motor load + all other motor loadsMOCP = 2.25 * largest motor load + all other motor loadsQuestion 2.I can have a 26KW electric heater that draws 76A added as an option to the above HVAC unit.How can my heater Overcurrent protection device for the heater be larger than the Maximum over current protection for the HVAC motors when they are the same unit?are the heater and compressor motors on separate breakers?Thanks
Question 1. Correct formulas for MCA and MOCP
The correct set of equations is: MCA = 1.25 largest motor load + all other motor loads MOCP = 1.75 largest motor load + all other motor loadsQuestion 2. Overcurrent protection for heater
The heater and compressor motors may be on separate breakers. This is because the heater has a higher amperage draw than the motors, and therefore requires a larger overcurrent protection device (OCPD).In this case, the heater draws 76A, while the largest motor load draws 16A. According to the formula for MOCP, the overcurrent protection device for the heater should be:MOCP = 1.75 * 16A + 2.8A + 3.0A = 45.5AThis is less than the heater's amperage draw of 76A. Therefore, the heater requires a larger OCPD than the HVAC motors. Flag for review