User: newt, Location: Logan, Utah
Asked on: Friday, March 11, 2011 at 4:20 pm EST
Answered on: Tuesday, May 14, 2024 at 2:41 am EDT
Question: Im doing a service to a horse barn. Putting a meter only on a 4x6 then going 200 feet to barn, inspector telling me that I would need to put a panel outside by the meter and run a 4 wire to the horse barn 200 feet away because it is agriculture. Is this true I have never heard of that? I cant find anything.
Requirement for a Panel and 4-Wire Feeder to an Agricultural Building
Yes, it is true that in most areas, the National Electrical Code (NEC) requires a panel and a 4-wire feeder to be installed for an agricultural building, such as a horse barn, if the following conditions are met: The building is classified as an "agricultural building" by the NEC. This means that it is used for the purpose of farming, such as housing livestock, storing crops, or performing other agricultural activities. The building is located more than 100 feet from the service entrance.Reason for the Requirement
The main reason for this requirement is to provide a safe and reliable electrical supply to agricultural buildings that are located a significant distance from the service entrance. The 4-wire feeder provides two hot wires, a neutral wire, and a ground wire, which ensures that the building has adequate electrical capacity and protection.
Requirements for the Panel
The panel installed at the meter location must be rated for the size of the load that will be served by the agricultural building. It must also have a main breaker or fuse to protect the feeder cable.
Requirements for the 4-Wire Feeder
The 4-wire feeder cable must be sized appropriately for the load and the distance of the run. It must be buried underground or run in conduit.
Exceptions
There are some exceptions to this requirement, such as when the following conditions are met: The agricultural building is used solely for residential purposes. The agricultural building is small and the electrical load is minimal.
Conclusion
In most cases, it is true that you will need to install a panel and a 4-wire feeder to an agricultural building that is located more than 100 feet from the service entrance. This requirement is in place for safety and reliability reasons. If you are unsure whether your situation qualifies for an exception, it is recommended to consult with a qualified electrician. Flag for review