User: physicianassistant, Location: Massachusetts
Asked on: Friday, March 11, 2011 at 8:00 pm EST
Answered on: Tuesday, May 14, 2024 at 2:42 am EDT
Question: The current service entrance cable on my house is attached to the front corner soffit and then runs vertically to the meter channel. From the meter channel the entrance cable travels less than 10 foot to the panel in the basement.Question is this: In order to complete my new timber frame porch I need to have the meter channel moved 20 foot along the side wall of the house. This will present with 2 issues for me. The first is can a cable be run along the soffit 20 foot back from the current attachment (at the front corner soffit) to the new meter channel or will the attachment to the house need to be moved so that the cable then runs vertically from the attachment to the meter channel. The second issue is a clarification. Since the new meter channel will be 20 feet from the service panel I will need a disconnect at the new meter channel correct?I am the contractor and need to set up everything for the electrician do the connections.Thanks!
Regarding the Cable Run
Yes, it is permissible to run the cable along the soffit 20 feet back from the current attachment to the new meter channel. However, the cable must be properly attached to the house using approved methods such as cable straps or saddles.
Regarding the Disconnect
Yes, since the new meter channel will be more than 6 feet from the service panel, a disconnect will be required at the new meter channel. This disconnect can be a fused or circuit breaker type.
Additional Considerations
The electrician should verify the capacity of the existing service entrance cable to ensure it is adequate for the new load. The electrician should install a grounding electrode system at the new meter channel location in accordance with the National Electrical Code (NEC).* The electrician should obtain the necessary permits and inspections for the work.
Setup for Electrician:
To prepare for the electrician:1. Determine the size and type of disconnect required based on the service requirements.
2. Mark the location of the new meter channel and prepare the necessary mounting surface.3. Plan the cable route along the soffit, ensuring proper attachment points.
4. Provide access for the electrician to connect the cable and install the disconnect. Flag for review