Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: How critical should an AHJ be?

User: nizak, Location: Raleigh NC

Asked on: Sunday, March 13, 2011 at 7:21 pm EDT
Answered on: Tuesday, May 14, 2024 at 2:45 am EDT

Question: I happened to be out walking today near my home and went past some 4 unit residential housing that is being put up. The units were not secured so I stepped into one and the first thing I see posted is the electrical rough in approval. Taking only a few minutes I could see a number of code violations that could have easily been avoided. (1) box fill w/pvc nail on's(mainly 2 gang's with 2 or more over box fill), NM cables improperly stapled(2 round 14/3 secured with half inch stapleles-not rated) NM stapled as close as 3/4 to stud edge, bored holes within 3/4 stud edge with no drive plates, home runs into panel fastened 3 feet from box and the list goes on. Are these types of items something that is usually overlooked because they are petty in nature? I am not perfect, but you would never find any of this type of work on my jobs because we follow the code.

Code violations, regardless of their perceived severity, should not be overlooked. They can have serious safety implications and should be addressed promptly.Here's why these violations are concerning: Overbox fill

Overfilling electrical boxes can lead to overheating, damage to the wiring, and increased risk of fires.


Improperly stapled NM cables

Stapling NM cables too closely to the edge of studs or using inadequate staples can damage the cable, compromising its integrity and increasing the risk of shorts or fires.

NM stapled too close to stud edge

Similar to the previous issue, stapling NM cables within 3/4" of the stud edge can weaken the cable and increase the risk of damage.


Bored holes within 3/4 stud edge without drive plates

Bored holes in studs should be reinforced with drive plates to prevent the studs from splitting and compromising the structural integrity of the building.*

Home runs fastened too far from the box:
Home runs (wires running to the electrical panel) should be secured within 8 inches of the box to prevent strain on the connections and potential damage to the wiring.These violations indicate that the electrical work was not performed to the required code standards. While some violations may seem minor, they can have serious consequences. It's important to ensure that all electrical work is done by qualified professionals who adhere to the applicable codes and standards. Flag for review

Previous Question Next Question