Yes, you can pass your wires from your main panel back through the meter can.Steps

1.

Shut off all power

Turn off the main breaker in your main panel and the generator breaker in the transfer switch.2.

Remove the meter

Carefully remove the meter from the meter can. This may require disconnecting a few wires.3.

Pass the wires

Feed the wires from the main panel through the opening in the meter can where the meter was located. Make sure the wires are protected from any sharp edges.4.

Reconnect the meter

Reinstall the meter into the meter can and reconnect any wires you disconnected.5.

Turn on the power

Turn on the main breaker in your main panel and then the generator breaker in the transfer switch. The generator should now be able to power your home.

Safety Precautions



Always wear proper safety gear

Gloves, safety glasses, and non-conductive shoes.

Never work on live wires

Ensure all power is shut off before starting any work.

Use extreme caution

The area around the meter can and main panel can be hazardous.

Contact a qualified electrician

If you are not comfortable performing this task, contact a licensed electrician for assistance.

Additional Notes: Make sure the wires you pass through the meter can are properly sized and rated for the application. Secure the wires inside the meter can to prevent them from moving or becoming damaged.* Keep the opening in the meter can sealed to prevent moisture or pests from entering. Flag for review