Mike Dolt Enterprises
Mike Dolt Enterprises
User: richwaskowitz, Location: Shelby Twp. MI, near Detroit
Asked on: Friday, April 22, 2011 at 9:55 am EDT
Answered on: Tuesday, May 14, 2024 at 4:32 am EDT
Question: I need to relocate the service drop on a low ranch home to get it away from going over a patio. If i were to run entrance cable up from the meter and then along the underside of the overhang to a point at the far end of the home and then penetrate the overhang with a rigid conduit riser to get the minimum clearance required, could someone help with with how would I make the transition to the sleeve and how would I bond it to the cable?
Transition to the Sleeve
1. Remove the outer jacket of the entrance cable approximately 12 inches from where it will enter the sleeve.
2. Strip the insulation from the individual conductors.3. Form a "bell" shape in the exposed conductors to create a smooth transition into the sleeve.
4. Insert the conductors into a flexible waterproof sleeve that is sized appropriately for the cable diameter.5. Secure the sleeve to the cable using waterproof tape or a sealant.
Bonding to the Cable
1. Wrap a bonding strap around the outer jacket of the entrance cable, approximately 6 inches from the sleeve.
2. Use waterproof tape or a sealant to secure the bonding strap to the cable.3. Attach the other end of the bonding strap to a grounding electrode or the grounding conductor of the rigid conduit riser.
Installation of the Conduit Riser
1. Cut a hole in the overhang to accommodate the rigid conduit riser.
2. Install a weatherhead on top of the conduit to prevent water infiltration.3. Run the conduit from the weatherhead to the service entrance panel.
4. Secure the conduit to the overhang using conduit straps or conduit hangers.
Additional Considerations: Ensure that the conduit riser meets the minimum clearance requirements from the patio or other obstructions. Use waterproof materials and seal all connections to prevent moisture from entering the cable or conduit. Obtain all necessary permits and inspections before starting the project. Consult with a licensed electrician if you are not comfortable performing electrical work. Flag for review