Wiring Diagram for McPhilben DEB-5W BallastMaterials

McPhilben DEB-5W Electronic Ballast Two T5 Fluorescent Lamps (28W or 39W) Wire connectors (wire nuts) Electrical tape

Steps

1.

Turn off power at the fuse or circuit breaker panel.2. Prepare the lamps

Insert the T5 fluorescent lamps into the corresponding lampholders on the ballast.3.

Connect the ballast

- Locate the four ballast wires extending from the ballast: two gray wires (input), two white wires (output).- Connect the two gray wires to the hot (black) and neutral (white) wires from the power source.- Connect the two white wires to the corresponding wires on the lampholders.4.

Secure the connections

Twist together all connections using wire connectors and secure the wires with electrical tape.5.

Check for correct polarity

Ensure that the gray wires are connected to the correct line voltage (120V or 277V).6.

Turn on power and test the ballast

Turn on the power at the fuse or circuit breaker panel. The fluorescent lamps should now be operational.

Additional Notes: The DEB-5W ballast is suitable for 28W or 39W T5 fluorescent lamps. The ballast has an input voltage of 120V or 277V. It is recommended to use the appropriate length and gauge of wire for the application. Always consult with a qualified electrician if you are not comfortable performing electrical work. Flag for review